Our work

A rear mudguard designed around the wheel and the original tail light, mounted on the scooter's own fixing points.

A pair of honeycomb vent grilles for a car bonnet. The first photo shows one straight off the printer, still on its supports.

A copy of an industrial electric motor's cooling fan, with the same number of blades and the same fit on the shaft. We made two units.

On the right, the broken original gear; on the left, the printed copy with the same teeth, ribs and bore.

Made to fit one specific hairdryer: it holds it by the body and leaves the cable free.

A decorative figure with the year on its base, a gift for the Year of the Horse. Printed in one piece with all the carved detail.

A shower head shaped like an open ring, designed and printed to order. Shown in use.

A prop helmet, printed, sanded and hand-painted with a weathered finish.

A pair of brackets with stiffening ribs and screw holes, designed to measure.

A ventilation duct with a round inlet, fresh off the printer and still on the tree supports that are removed afterwards.

A decorative torso-shaped vase printed in dark blue.

A wall-mounted organiser with a cup, slots for four toothbrushes and room for the toothpaste.

A faceted hare figure printed in white.

A bathroom shelf that also holds the toilet roll, fixed to the wall with two screws hidden under caps.

A wall cover with wavy slats that hides the router and its cables. The antenna stays outside and the slats let air through.